HS52 wird nicht mehr produziert

Simrad HS52 GPS compass

Gyro, GPS and speed log in one compact navigation package

True heading anywhere on earth
Heading accuracy unaffected by the latitude
Heading available in periods of GPS drop-outs
Replaces several instruments
Supports SBAS differential corrections
Only two-pair cable (no coax) between the mast unit and the Prosessing unit on the bridge
20 Hz update rate on heading, rate of turn and position measurements
Three RS-232 and three RS422 configurable output serial lines
IMO type approved as DGPS navigator Positioning Sensor
IMO type approved as THD (Transmitting Heading Device)
Output data on Ethernet

All in one

The HS52 is the most responsive GPS compass outputting true heading with no moving parts, reducing the requirement for service dramatically. Position, speed and rate of turn information are extras that come standard with this product.

Economic and reliable

The HS52 replaces several vessel instruments, such as a gyrocompass, GPS navigator and speed log in one compact navigation package. In addition the HS52 provides added position redundancy with two complete GPS receivers.

Perfect accuracy

Precision heading is derived from the fixed-distance dual GPS antenna arrangement in the Sensor unit, using carrier phase data to generate heading information independent of latitude and vessel dynamics. GPS position and velocity are calculated from both of the two antennas, which gives total redundant position and velocity sources in this product. Input of DGPS corrections or reception of SBAS (WAAS/EGNOS) signals may improve the position accuracy.

The inertial element provides yaw information. In case of short GPS signal loss, the inertial rate sensor automatically takes over as the prime source for heading determination until the GPS comes back on line. The rate element and GPS are working together seamlessly, continuous and robust heading information.

Easy to install and operate>

The HS52 requires no scheduled maintenance or re-calibration. The HS52 offers a flexible configuration of the output variables and interface setups, depending on the vessel and application. Easy installation with only one single cable from Processing unit to the Sensor unit.